How to choose right AG glass for your touchscreens display?

AG spraying coating glass

AG spray coating glass is a physical process that uniformly coats submicron silica and other particles on the glass surface in a clean environment. After heating and curing, a particle layer is formed on the glass surface, which diffusely reflects light to achieve anti-glare effect, this method does not damage the glass surface layer, and the thickness of the glass increases after processing

Thickness available: 0.55mm-8mm.

Advantage: yield rate is high,competitive cost.

Disadvantage: comparably inferior durability and weather resistance.

Application:touchscreens and display for indoor like interactive whiteboards.

sdyerd (1)

AG etching glass

AG etching glass is to use a chemical reaction method to change the glass surface from a smooth surface to a micron particle surface to achieve anti-glare effect. The process principle is relatively complex, which is the result of the combined action of ionization equilibrium, chemical reaction, dissolution and re-crystallization, ion replacement and other reactions. As the chemicals will etch the glass surface,so the thickness decreases after finish

Thickness available:0.55-6mm

Advantage:superior adhesion and durability, High environmental and temperature stability

Disadvantage:comparably lower yield rate,cost is high

Application:touch panel and display for both outdoor and

indoor.automotive touch screen,marine display,industrial display etc

sdyerd (3)
sdyerd (2)

Base on those,for outdoor use,AG etching is best choice,for indoor use,both of them are good,but if with limited budget,then AG spraying coating glass goes first